The factory default mode for these devices is to use PPPoE. To change it to bridge mode, do the following:
- Connect a computer up to the Ethernet port. Make sure your computer is set as a DHCP client (obtain address automatically)
- From your browser, go to http://192.168.1.254
- Click the Advanced link on the left side of the page
- Click the PPP location link that will appear.
- You may get prompted to enter the modem access code at the point. If so, you will find this code on a yellow sticker on the bottom of the modem.
- Click the button that says “PPP is on the computer, gateway, or router” and then save changes.